Rinnai 2402 Specifications download pdf (Page 35)

Model 2402 800-621-941935

INSTALLER’S INSTALLATION INSTRUCTIONS

Remote Controls - Installation

securing screw

wire hole

outline of remote

3 1/4 inches

1 1/16 inches

21/32 inch

1) Determine a suitable location for the

control.

2) Make three holes on the wall as

shown.

3) Run the cable between the control

and the Continuum 2402 or the

control and the other control.

4) Remove the face plate from the remote control, using a screw driver.

5) Connect the cable to the remote control.

6) Mount the control to the wall using the holes drilled in step 2.

Note: If the cable cannot be run in the wall cavity, the plastic knockout should be

removed from the top or bottom of the control to allow flush mounting with

the wall

7) Disconnect the power from the Continuum 2402.

8) Remove the cover of the Continuum 2402.

9) Remove the plastic cover from the PCB and electrical connections.

DO NOT ATTEMPT TO CONNECT THE REMOTE CONTROLS

WITH THE POWER ON, THERE'S 120 VOLT POTENTIAL,

NEXT TO THE REMOTE CONTROL CONNECTIONS INSIDE

THE UNIT. All service and wiring should be performed by a

certified installer.

10) Thread the cable through the access hole at the

base of the unit and connect the wires to the control

terminals on the right hand side bottom of the PCB.

11) Secure the control cable using the clamp provided.

12) Replace plastic cover over PCB and then replace the

cover of the Continuum 2402.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

No comments

Rinnai 2402 Specifications Page 35