Rinnai RHFE-1001FA Installation Manual download pdf (Page 35)

– 33 –

ERROR MESSAGES

In all cases, you may be able to clear the Error Message simply by turning the heater OFF, then ON again.

If the Error Message still remains or returns on the next operation, contact Rinnai or your nearest service

agent and arrange for a service call.

The Energysaver 1004 has the ability to check its own operation continuously. If a fault occurs, an Error Message

will flash on the Digital Display of the control panel. This assists with diagnosing the fault, and may enable you to

overcome a problem without a service call. Please quote the code displayed when inquiring about service.

CODE DISPLAYED FAULT REMEDY

Ignition failure

Flame failure

Overheat

Room overheat

Room Temperature

Sensor faulty

Overheat Temperature

Sensor faulty

Sparker failure

Combustion fan failure

Faulty ON/OFF switch

Faulty solenoids

Faulty Flame Rod

Communication Error

Check gas is turned ON.

Service call if repeated.

Check gas is turned ON.

Service call if repeated.

Clean filter

Service call if repeated.

Service call.

Turn heater OFF,

then ON again.

Lower room temperature

to less than 40°C(104°F).

Flue block

Check around flue terminal

Sensor breakdown

Service Call.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

No comments

Rinnai RHFE-1001FA Installation Manual Page 35