Rinnai REH-311FT(C) Installation Manual download pdf (Page 8)

Rinnai Australia 5 Ultima II Operation Manual

BASIC USER GUIDE

Below is a guide to the basic operation of the Ultima II heater. For details on how to

use the advanced features of this appliance please read pages 6 to 11 of this manual.

NOTE

When the heater has started to heat the room the On/Combustion indicator will

change from Green to Red (steady illumination) to confirm heater operation.

This number indicates the current (CURR) room temperature.

(The SET temperature must be higher than this temperature for the heater to start)

Use the up arrow to raise the room temperature and use the down arrow to

lower it .

This number indicates the selected (SET) room temperature.

(The available SET temperatures are: L = low, 16°C to 30°C in [ 1°C steps ], H = high)

To turn on the heater press the STANDBY/ON button, the On/Combustion indicator

will illuminate Green (steady illumination) until the heater starts.

Press the SET button until the desired mode(s) are shown in the display.

(For best comfort and economy press the SET button until GAS, ECON & AUTO OFF are

all shown. The last mode(s) sellected become the default the next time the heater is used)

To turn off the heater press the STANDBY/ON button, the On/Combustion indicator

will go out and the digital display will revert to a CLOCK display for 10 seconds and

then go blank.

(The fan will continue to cycle for several minutes to cool the heater down)

--:--

time

GAS ECON

weehen0

AM PM

AUTO OFF

1 7

436

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Rinnai REH-311FT(C) Installation Manual Page 8