Rinnai REH-311FT(C) Installation Manual download pdf (Page 15)

Rinnai Australia 12 Ultima II Operation Manual

CARE AND MAINTENANCE

Your heater needs very little maintenance, but the following information will help you to keep it looking

good and working efficiently.

CLEANING FILTERS, GRILLES AND LOUVRES

The burner filter , air inlet louvre , warm air discharge louvre and thermistor grill cover must

be kept clear of dust or other obstructions.

Dust contamination of these parts reduces the heating effectiveness of the appliance and may require

cleaning at least once a week during the heating season to prevent blockages.

SERVICE

Rinnai recommend that this appliance and installation be inspected and serviced every 2 years.

If the power supply cord or any other component of the heater are damaged, they must be replaced

by Rinnai or a suitably qualified person.

Any service or repair work should only be carried out by an authorised person. Rinnai has service and

spare parts departments nationally see back cover for contact details.

Unplug before cleaning.

All parts of the heater can be cleaned using a soft, damp cloth.

DO NOT use solvents to clean any parts.

DO NOT spray aerosols in the vicinity of the heater whilst in operation.

DO NOT place articles on or against this heater.

DO NOT store flammable materials near this heater.

DO NOT wait for FILTER indicator to

illuminate on the display of the control panel

on before cleaning these areas.

DO NOT use the heater with the FILTER

indicator illuminated. This may cause

the appliance to overheat.

Service calls for general cleaning, maintenance and wear and tear are not necessarily

covered under the warranty. Service calls of this nature may be chargeable.

IMPORTANT

i0:30

timeroff

GAS ECON

weehen0

AM PM

AUTO OFF

NOTE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Rinnai REH-311FT(C) Installation Manual Page 15