Rinnai Symmetry RDV3611 Installation Manual download pdf (Page 8)

8 | RDV3611 Operation Guide: 11158-B 02-13

Wireless controller

Your wireless controller is designed to be wall mounted on a bracket, supplied with the

controller, within 10 m of the ﬁre.

How it operates

The controller houses the

thermostat that senses the room

temperature and communicates

information back to the Symmetry

RDV3611 via radio frequency.

It needs to be positioned in the

same room as the Symmetry

RDV3611 and the area that requires

heating—a place not subject

to temperature ﬂuctuation.

For example; if placed near a

door subject to cold drafts, the

controller will sense the room

is much colder than it is and the

RDV3611 will keep heating the

room, when in reality the set

temperature has been reached.

Controller position

The ideal position for the

controller is:

- away from possible drafts in

the room

- away from direct sunlight

- a suitable distance away from

the heater, approx. 2-10 m

- ideally 1.5 m from the ﬂoor

(approx. at chest height when

standing)

Controller dimensions

Height: 140 mm

Width: 80 mm

Depth: 20 mm

Battery

Type: 2 x AA batteries

Life: Approx. 12 months

When the batteries are changed

all settings will be lost and the

controller will revert back to the

initial setup screen.

Handy tips

The most eﬃcient way of

operating your Symmetry RDV3611

is with the wireless controller.

Once the unit has been turned

on at the wall for the ﬁrst time,

and the ON button pressed on

the unit’s control panel, use the

wireless controller to turn the unit

on and oﬀ (not the button on the

appliance).

If you turn the appliance on with

the button on the control panel,

make sure the wireless controller

is also turned on (otherwise the

appliance will turn itself oﬀ).

If you do turn the appliance oﬀ

with the button on the appliance

you will need to turn it on again

with the button on the appliance—

you won’t be able to turn it on with

the remote.

If the appliance is not going and

the LED, on the control panel, is

permanently on, push the ON/OFF

button next to the LED twice to get

the appliance to re-ignite.

If the LED on the appliance is

oﬀ check the ﬂame symbol on

the wireless controller; if it is

pulsing, the appliance is still on

and will relight when the room

temperature drops.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments