Rinnai Symmetry RDV3611 Installation Manual download pdf (Page 11)

RDV3611 Operation Guide: 11158-B 02-13 | 11

Modes of operation

Automatic Flame control

Manual

- Temperature can be set at any

level.

- Time and day of week does not

need to be set.

With the controller turned on,

press and release the A/M button

until the word ‘MANUAL’ appears

on the LCD. Press and hold the ‘UP’

and ‘DOWN’ buttons to increase/

decrease the temperature by 1 °C.

- Temperature is regulated to a

programmed level and time.

- Time and day of week needs to

be set.

- At any time the temperature

may be adjusted up or down.

Allows you to set your preferred

ﬂame setting and override the set

temperature—your heater will not

automatically turn itself oﬀ (unless

the room exceeds 40 °C).

To activate the ﬂame mode:

1. Turn the controller on (PWR +

OK)

2. Press the A/M button until

the MANUAL or AUTO symbol

disappears from the bottom of

the LCD.

3. The LCD will display what is

shown in the image below.

Use the UP and DOWN button

to adjust the ﬂame setting

(seven ﬂame stages in total).

When using for the ﬁrst time,

the controller will default to

F1 (lowest setting), and then

default to the last selected

ﬂame setting when used again.

A/M PWRT P

DOWN

UP

OK

1. Flame setting

Flame symbol will correspond to

the ﬂame setting selected—F7-F1

(highest to lowest).

2. Flame mode

Nothing will be displayed in this

window when operating in ﬂame

mode.

1

2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments