Rinnai GT4SB-S Specifications download pdf (Page 30)

www.rinnai.us

INSTALLER’S INSTALLATION INSTRUCTIONS

Electrical Connection Notes

WARNING: The Continuum V2532W must be electrically grounded in

accordance with local codes or in the absence of local

codes with the most recent edition of the National Electrical

Code, ANSl/NFPA 70 and/or the CSA C22.1, Electrical Code.

Do not rely on the gas or water piping to ground the metal

parts of the water heater.

CAUTION: Label all wires prior to disconnection when servicing

controls. Wiring errors can cause improper and dangerous

operation. Verify proper operation after servicing.

1 The Continuum V2532W requires

120VAC/60 HZ. Power from a properly

grounded circuit.

2 An on/off switch must be provided and

installed for the incoming 120VAC

power.

3 Wire the Continuum V2532W exactly as

shown in the wiring diagram on the

next page and on the inside of the

cover panel. The black wire is the hot

leg wire; the white wire is the neutral

wire.

4 A ground terminal screw is provided in

the junction box for the grounding

connection (see diagram).

Your disconnect switch should be a type

that is suitable for outdoor use. Check

National Electrical Codes for proper type

switch to use in your area.

Model V2532W30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

No comments

Rinnai GT4SB-S Specifications Page 30