Rinnai GT4SB-S Specifications download pdf (Page 16)

TROUBLE SHOOTING AND COMMON QUESTIONS

- When I was using the hot water, the water got cold!

- If you adjusted the flow from the tap to lessen it, you may have gone

below the minimum flow required. The Continuum V2532W requires 0.5

GPM to operate. If you mix the water with a tap and attempt to get a

temperature well below the temperature being controlled by the unit, it

may drop the flow below 0.5 GPM. Decrease the temperature supplied

by the Continuum V2532W at the remote control or increase your total

flow.

- White smoke comes out of the exhaust!

- During colder weather when the exhaust temperature is hotter than the

air, the exhaust fumes condense producing white steam.

- When I open a hot tap. I do not immediately get hot water!

- Hot water must travel through your plumbing from the Continuum

V2532W to the faucet. This can take up to 2 or more minutes depending

upon your plumbing system. If hot water is disired instantly at the hot

water fixture, a circulaton loop system must be installed. Please

contact your plumber for details.

- After I turn off the hot water tap, the fan on the Continuum V2532W

continues to run!

- The fan is designed to be on for 65 seconds after the flow of water

stops.This is to ensure constant water temperatures during rapid

starting and stopping, as well as exhausting any residual gas flue

products from the unit.

www.rinnai.us

Model V2532W16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

No comments

Rinnai GT4SB-S Specifications Page 16