Rinnai Symmetry RDV3611 Installation Manual download pdf (Page 18)

Rinnai Australia 15 Operation & Installation Manual

CARE AND MAINTENANCE

Your heater needs very little maintenance, but the following information will help you to keep it looking

good and working efficiently.

GENERAL OPERATION CHARACTERISTICS

SERVICE

Rinnai recommend that this appliance and installation be inspected and serviced every 2 years or

more frequently.

If the power supply cord or any other component of the heater are damaged, they must be replaced

by Rinnai or a suitably qualified person.

Any service or repair work should only be carried out by an authorised person. Rinnai has service and

spare parts departments nationally. See back cover for contact details.

DO NOT attempt to clean the heater while the appliance is hot or operating.

All parts of the heater can be cleaned using a soft, damp cloth.

DO NOT use solvents or abrasives to clean any parts.

DO NOT spray aerosols in the vicinity of the heater whilst in operation.

DO NOT place articles on or against this heater.

DO NOT store flammable materials near this heater.

NOTE: Before asking for a service call please check the following table as these characteristics are

part of the normal operation of the appliance and do not indicate a fault.

CHARACTERISTIC EXPLANATION

At ignition:

Warm air does not start when the burner

lights.

The room fan air is started automatically after a

short delay. This is to allow the heat exchanger to

warm up, helping to avoid cold draughts.

Smoke or strange smells are produced on

the first start up after installation.

This is caused by grease, oil or dust on the heat

exchanger. This will stop after a short time.

Sharp clicking noises at ignition, or when the

unit thermostat modulates to a lower or

higher setting, or shuts down.

This is simply expansion and contraction noise

from the heat exchanger.

During combustion:

Dull clunking noise when the thermostat

operates

This is the sound of the solenoid gas valves

opening and closing to regulate the gas flow.

When the appliance is turned off:

Convection fan continues to run after turning

‘OFF’.

This is to remove residual heat from the heat

exchanger and stops once the appliance cools.

Service calls for general cleaning, maintenance and wear and tear are not necessarily

covered under the warranty. Service calls of this nature may be chargeable.

Faults caused by insufficient gas supply, gas quality, installation errors or operation

errors are not covered by the Rinnai warranty. Refer to separate Warranty Card for

details.

IMPORTANT

NOTE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments

Rinnai Symmetry RDV3611 Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Fireplaces Rinnai Symmetry RDV3611