Rinnai Symmetry RDV3611 Installation Guide download pdf (Page 10)

10 | RDV3611 Installation Manual: 11156-A 01-12

Building the frame

Using the dimension information on page 5, construct the frame. Ensure a 25 mm clearance

around the sides and back of the unit.

Electrical connection

The standard electrical connection is to the right side of the front of the appliance. If

necessary this can be changed by an electrician to terminate on the left. The appliance must

not be located immediately below a socket outlet as this could be a potential ﬁre hazard.

The connection is either direct

wired or connected to a power

point within the cavity.

A 1500 mm power cord is supplied

with a 3-pin plug. This must be

connected to a dedicated earthed

power point. The electric isolation

switch must be accessible after the

appliance has been installed.

The electrical cord is not ﬁre rated

and should not come into contact

with the ﬁre. If the supply cord is

damaged, it must be replaced by

a licensed tradesperson. This must

be a genuine replacement part

available from Rinnai, part number

6765B.

250 mm

Bracket installation

Install the four mounting brackets supplied onto the Symmetry RDV3611. The position of the

brackets will depend on the cladding thickness, and type of installation (framed or frameless).

The Symmetry RDV3611 can

be installed with Rinnai granite

and metal frames, and also as

a frameless installation. The

frameless installation can have

brick, rock veneer, or tiles, these sit

tight up against the framing plate

of the ﬁreplace.

The metal mounting bracket

adjusts 20 mm to allow for the

different cladding thicknesses.

Rinnai granite or metal

frame—bracket in

forward position, and

backing board around

framing plate.

Rinnai brick or tile

installation (note depth of

brick recess)—bracket in

middle position. Front face

of backing board level with

back face of framing plate.

Frameless brick or tile

installation (note cutaway

in brick for shallower

recess—bracket in back

position. Front face of

backing board sitting

behind the framing plate.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Rinnai Symmetry RDV3611 Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Fireplaces Rinnai Symmetry RDV3611