Rinnai Elevate User Manual download pdf (Page 15)

Rinnai New Zealand

Steel Frame Console Installation Manual: 11316-C 03-09

Spacer Module Assembly

Installing a

see-through

unit?

Go straight to next step - Fit lower frame together.

YES

Determine cladding material and thickness.

Loosely put base internal spacers together and mark on each where you

will trim. Double check this measurement with a tape measure against

suggested dimensions on page 7.

Cut spacer/connector modules to size using an angle grinder or tin

snips.

Refer photos on page 9 as a guide for how to complete.

Make up

individual

spacer sections

Make up individual spacer sections and secure with screws provided (8

into each frame). Ensure all side studs (SN-1 and SN-2) are placed INSIDE

the top and bottom plates. Also note diagonal brace alignment with hole

position on top and bottom plates.

note hole position on top and bottom plate for diagonal brace

all side studs slot INSIDE the top and bottom frames

Congure

spacer sections

Place individual assembled sections into position. Short plates form the top

and bottom, not the sides as shown in ‘Incorrect conguration’.

Correct conguration



Incorrect conguration

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Rinnai Elevate User Manual Page 15