Rinnai 0901 7042 Installation Manual download pdf (Page 16)

Rinnai New Zealand Compact Op/Install Manual: 10170-C 02-09

Installation Information - Installation

Gas connection

Gas pipe sizing must consider the gas input to this appliance as well as other appliances in the

premises. The gas meter and regulator must be specied for the total gas rate. An approved

sizing chart such as the one in NZS:5261 should be used.

Copper supply should be run leaving a ared connection at the position shown. The gas

supply terminates inside the heater and enters the appliance from the rear. As this is a are

connection, sealant is not recommended.

260

½" BSP MALE FLARE

Purge supply of air and debris

All foreign materials such as lings must be purged from the gas supply, as they may cause

the gas control valve to malfunction.

Fit heater into place

When the heater is in place and properly secured, attach the gas supply to the supplied barrel

union and tighten.

On completion of work a gas leak test must be carried out. Use a soapy solution on all gas

connections. Leaks will be visible when the soapy solution forms bubbles. When nished, wipe

soapy solution with a rag to remove residue.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Rinnai 0901 7042 Installation Manual Page 16