Rinnai 0901 7042 Installation Manual download pdf (Page 10)

Rinnai New Zealand Compact Op/Install Manual: 10170-C 02-09

Installation Information - General

Before installation

Unpack the appliance and components and check for damage. DO NOT install any

damaged items.

Check all components have been supplied and that you have the correct gas type.

Read these instructions to get an overview of the steps required before starting the

installation. Failure to follow these instructions could cause a malfunction of the

appliance. This could result in serious injury and property damage.

Specication information

Data Plate Inside appliance - bottom panel front right hand side

Dimensions H-645 mm, W-750 mm, D-277 mm

Fan Type Tangential 2-speed, rating 28 W

Flue - Masonry Rinnai strongly recommends the use of a Rinnai Flexiliner Flue system. Failure to meet this

criteria may result in an unsafe situation. Installation without a exiliner ue is permissible

as long as the chimney is checked for soundness and ability to achieve a good draw.

Terminal 43 mm x 245 mm rear discharge (spigot)

Flue - Decorative Natural draft twin skin ue. Termination, an approved 100 mm cowl must be tted to

all installations. Decorative chimney installations require a Zero Clearance Box and Zero

Clearance Flue Kit. Flue dimensions, outer - 150 mm, inner - 100 mm.

Gas Connection ½ “ BSP male are to barrel union

Gas Type NG or LPG

Noise Level 49 dB(A)

Power Consumption High 80 W, Standby 4 W

Weight 39 kg

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Rinnai 0901 7042 Installation Manual Page 10