21 Rinnai CVent
Installaon Instrucons
Recommended Spacing of Water Heaters
Spacing of the water heaters is crical for the common vent
system to mounng easily and securely. The collectors are
made for 20.5” spacing (center line to center line) between
water heaters. If a dierent spacing is needed, please
contact Rinnai concerning your applicaon. Rinnai
recommends using our Tankless Rack System (TRS) which is
designed for 20.5” spacing. Our engineered system is
designed to make installaon simple which greatly reduces
labor me and the chance of miscalculaons.
Custom Water Heater Spacing
If common venng with LESS than 20.5” between water heaters:
• The installer assumes all responsibility of following local codes. Inspectors can reject the installaon if the
rang plate cannot be seen for all water heaters.
• D4 Extension Pieces must be cut appropriately to maintain the required 3° slope.
If common venng with GREATER than 20.5” between water heaters:
• The installer must purchase a vent extension cut to the appropriate length between the collectors.
• The length of each addional vent extension must be considered in the maximum allowable vent length.
• D4 Extension Pieces must be cut appropriately to maintain the required 3° slope.
NOTE: Never attempt to cut or modify the
collectors.
To maintain a 3° slope, use the following
formula to calculate D4 Extension Piece
length (L):
(L) = (water heater spacing) X 0.05
Example: if the adjacent water heater is
20.5” away
Length (L) = 20.5” x 0.05 = 1.02”
Example: if the adjacent water heater is
26” away
Length (L) = 26.0” x 0.05 = 1.30”
Vent extension -
cut to size
Air Intake -
extension
D4 Extension
Piece
Comments to this Manuals