Rinnai EX11C Installation Manual download pdf (Page 29)

Rinnai Corporation EX08C, EX11C Manual 29

Operating Instructions

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING

If you do not follow these instructions exactly, a fire or explosion

may result causing property damage, personal injury or loss of life.

A.This appliance does not have a pilot. It is equipped

with an ignition device which automatically lights

the burner. Do not try to light the burner by hand.

B.BEFORE OPERATING smell all around the

appliance area for gas. Be sure to smell next to

the floor because some gas is heavier than air and

will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not use any

phone in your building.

• Immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s

instructions.

• If you cannot reach your gas supplier, call the fire

department.

C.Use only your hand to push in or turn the gas control

knob. Never use tools. If the knob will not push in

or turn by hand, do not try to repair it, call a

qualified service technician. Force or attempted

repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under

water. Immediately call a qualified service

technician to inspect the appliance and to replace

any part of the control system and any gas control

which has been under water.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to lowest setting.

2.Turn off all electric power to the appliance using the

ON/OFF button on the control panel.

3.Locate the manual gas valve on the side of the unit.

Turn the manual valve clockwise to the full

OFF position.

NOTE: The fan will continue to operate until the

appliance is cool. Do not turn the appliance off

by unplugging it from the wall. Keep burner

and control compartment clean.

OPERATING INSTRUCTIONS

STOP! Read the safety information above.

1. Set the thermostat to lowest setting.

2. Turn off all electric power to the appliance using

the ON/OFF button on the control panel. Locate

the manual gas valve on the back side of the

heater.

3. Turn the manual valve clockwise to the full

OFF position.

4. Wait five (5) minutes to clear out any gas. Then

smell for gas, including near the floor. If you smell

gas, STOP! Follow “B” in the safety information

above. If you don’t smell gas, go to the next step.

5. Turn the manual gas valve counterclockwise

to the full ON position.

6. Turn on all electric power to the appliance using the

ON/OFF button.

7. Set the thermostat to desired setting.

8. Burner is lit when indicator lamp “ON turns red.

9. “ON” indicator and fault code 11, flash when burner

fails to ignite.

10. If the appliance will not operate, follow the

instructions “To Turn Off Gas To Appliance” and

call your service technician or gas supplier. See

manual for additional information.

Manual Valve

OPEN

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

Comments to this Manuals

No comments

Rinnai EX11C Installation Manual Page 29

Comments to this Manuals

Related products and manuals for Unknown Rinnai EX11C