Rinnai EX11C Installation Manual download pdf (Page 10)

10 Rinnai Corporation EX08C, EX11C Manual

CAUTION

Humidifier and Air Flow Direction

Adjusting Air Flow Direction

The vertical louvers may be adjusted to move the air

flow more to the right or to the left.

Use a screw driver or similar object to bend each

louver to the desired position.

Do not bend repeatedly (no more than 5 times) or else

the louver will break.

The horizontal louvers (which determines the vertical

air flow direction) are fixed and cannot be adjusted.

Do not adjust the air flow

louvers while warm air is

flowing.

Adding Water to the Humidifier

Warm air is humidified when it passes over the water

in the tray.

To fill the tray, remove the bottom panel by pushing on

both sides and pulling it toward you. Pull the tray out

and fill with water. Do not exceed the fill line. Push

the tray back in and attach the bottom panel. Do not

operate the appliance unless the humidifier tray is

installed.

During operation a small amount of condensation is

produced in the flue system and drains into the

humidifier tray.

CAUTION

Do not remove the bottom

trim panel or the humidifier

tray while warm air is

flowing.

Set back

This function allows a minimum room temperature to be pre-set,

between 38ºF and 78ºF (in 2ºF increments). This temperature

should be set below the room temperature setting. The default

setting is 60ºF. Once the Set back function is selected the appliance

will start heating whenever the room temperature falls below the

selected temperature, regardless of timer or manual settings.

Follow these steps to set and operate the Set back feature:

1. Make sure the heater is turned OFF.

2. Press the “Set back” button. The light above the button will

come on.

3. Press the up and down buttons to set the minimum temperature.

When the “Set back” indicator is on, frost protection is operating,

and will always prevent the room temperature from falling below the

pre-set minimum temperature (as long as electric power and gas is

supplied).

To turn this feature off, press the “Set back” button.

The unit will retain its ON or OFF setting after a power failure.

(Default setting at the factory is on.)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 79 80

Comments to this Manuals

No comments

Rinnai EX11C Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Unknown Rinnai EX11C