Rinnai ES17 Installation Manual download pdf (Page 9)

Rinnai Corporation ES17 / ES22 Manual

CAUTION

Adjusting Air Flow Direction

The vertical louvers may be adjusted to move the air

flow more to the right or to the left.

Use a screw driver or similar object to bend each

louver to the desired position.

Do not bend repeatedly (no more than 5 times) or else

the louver will break.

The horizontal louver (which determines the vertical air

flow direction) is fixed and cannot be adjusted.

wolf ria eht tsujda ton oD

louvers while warm air is

flowing.

Operating the Heater Manually

Adding Water to the Humidifier

Warm air is humidified when it passes over the water

in the tray.

To fill the tray, remove the bottom trim panel below the

louvers by pulling on both sides. Pull the tray out and

fill with water. Push the tray back in and attach the

bottom trim panel. Do not operate the appliance

unless the humidifier tray is installed.

During operation a small amount of condensation is

produced in the flue system and drains into the

humidifier tray.

CAUTION

mottob eht evomer ton oD

trim panel or the humidifier

tray while warm air is

flowing.

Lock

This feature locks the buttons to

prevent unintended operation.

Press the Lock button to activate and

the lamp will glow. Pressing and

holding the Lock button for two seconds

will disengage the Lock.

If the Lock is engaged while the unit is

operating, all buttons will be disabled

except for the ON/OFF button.

If the Lock is engaged while the unit is

off, then all buttons will be disabled. The Lock must

be disengaged in order to turn the unit on.

Filter Lamp

If the filter lamp flashes during

operation, check the air filter for

dust. If dust is present, clean the

filter. See the Care and

Maintenance section. Turn the

heater off before cleaning the filter.

When the filter lamp flashes, the

beep is known 5 times every

5 minutes.

Filter

ON/OFF

Sensible Temperature Control

The sensible temperature control feature allows

comfortable heating which matches the conditions in

the room.

Based on the information collected by the room

temperature thermistor when the heating starts, the

heating capacity is automatically adjusted to achieve

a comfortable heating effect and to reach the

temperature setting quickly.

Lock

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments

Rinnai ES17 Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Fireplaces Rinnai ES17